A-1 CARDONE part description

Front Left

Product Description

Brake Caliper

Application Summary

Pontiac Fiero 1988

Features & Benefits

  • Pistons are durable, resistant to cracking or pitting and handle great loads.
  • Rubber seals are replaced with new high temperature EPDM rubber for extended life and optimum performance.
  • Mounting bracket is included where applicable for a hassle-free installation.
  • Calipers are treated with a special formulated rust inhibitor and kept in the original equipment finish.
  • New banjo bolts are included where applicable to ensure a perfect fit and quick installation.
  • New bleeder screws provide trouble-free bleeding and a positive seal.
  • New washers are included where applicable for a proper seal.
  • A plastic cap plug protects every brake port thread to ensure trouble-free installation.
  • New stainless steel hardware clips and new mounting pins are included where applicable.
  • As a remanufactured Original Equipment part, this unit guarantees a perfect vehicle fit.
  • Our remanufacturing process is earth-friendly, as it reduces the energy and raw material needed to make a new part by 80%.

Caliper, Brake Caliper, Disc Brake Caliper, Unloaded Caliper, Unloaded Brake Caliper, Power Brake Caliper, Hydraulic Disc Brake Caliper, Brakes

Product Attributes

Inlet Port Size 0.39
Piston Quantity 1
Piston Material Steel
Package Contents Caliper; Instruction Sheet; Hardware Kit
Bleeder Port Size M10x1.5
Brake Caliper Finish Oil Emulsion
Installation Hardware Included Yes
Pads Included No
Mounting Bolts Included No
Product Condition Remanufactured
E-waste No
Piston Size (OD) (mm) 47.83
Piston Size (OD) (in) 1.88
FAQs What type of grease is used on floating caliper mounting pins?
Features and Benefits Rubber seals are replaced with new high temperature EPDM rubber for extended life and optimum performance.
Caliper Color Gray
Abutment Clips Included No
Anti-Rattle Spring Included No
Bleeder Screw Included Yes
9559 1
Bracket Included No
Caliper Casting Material Aluminum
Caliper Color Gray
9611 Oil Emulsion
Caliper Slides Included Yes
Caliper Type Floating
Casting Number 7529
Grade Type Regular
Inlet Fitting Type Banjo
9544 M10x1.5
Mounting Bolt Included No
Mounting Bracket Included No
Mounting Hardware Included Yes
Mounting Hole Diameter 1.022 IN
Mounting Hole Diameter 25.94858 MM
9543 1.022 IN
9543 25.94858 MM
Pad Wear Sensor Included No
Pads Included No
7609 47.8282 MM
7609 1.883 IN
Piston Material Steel
Piston Quantity 1
Bleeder Screw Cap Included No
Rust Resistant Coating Yes
Dust Boots Included Yes
Bleeder Thread Size M10x1.5
Inlet Port Size 10.00366 MM
Inlet Port Size 0.394 IN
Contains Electronic Components No
Does it require SDS No
Is Item A Chemical No
Is Or Contains A Battery No
Is Or Contains A Bulb No
Is Prop Sixty Five Affected No
Is the item CARB affected No
FAQ_Q1 Can I switch out a Phenolic Piston Caliper for a Steel Piston Caliper or vice versa?
FAA_A1 Not recommended. The O.E. manufacturers specified steel or phenolic pistons based on the intended use of the vehicle. It is recommended that the installer follow the manufacturer’s recommendations.
FAQ_Q2 What type of fluid should I use: DOT 3, DOT 4, or DOT 5?
FAA_A2 As a rule, always use brake fluid recommended by O.E. The fluid type is stamped on the master cylinder reservoir lid. Always use new fluid in a sealed container.
FAQ_Q3 Car pulls to one side during braking. Why?
FAA_A3 Inspect both calipers for binding or sticky slides or pins. Also ensure that brake hoses are not collapsed or restricted and inspect steering/suspension components for proper operation.
FAQ_Q4 Brakes squeal all of the time. What's causing the squeal?
FAA_A4 Brake squeal can be caused by improper installation of the brake pads, improperly installed brake hardware and improper brake rotor finish.
FAQ_Q5 Could calipers be the cause of a low brake pedal?
FAA_A5 A symptom of a low brake pedal is usually caused by air in the system, misadjusted rear brake shoes, deteriorated brake hose(s) or a defective master cylinder.
FAQ_Q6 What type of grease is used on floating caliper mounting pins?
FAA_A6 A silicone grease is used on floating caliper mounting pins.
FAQ_Q7 Do all of your Calipers come with the new hardware and a mounting bracket for installation?
FAA_A7 New hardware is included with all of our Calipers however the mounting bracket is an added option depending on part number and application. Mounting Brackets are also sold separately for most applications.

Additional Information

Remanufactured Part Y
Warranty Distance 24000
Warranty Distance UOM DH
Warranty Special UOM TX
Warranty Time 24
Warranty Time UOM MO
Country of Origin (Primary) US
Harmonized Tariff Code (Schedule B) 8708300050
Harmonized Tariff Code (HTS) 8708305090
Canadian Harmonizing Tariff Code 8708309920
UPC 00082617153706

Part Interchanges

Fits Vehicles

  • Pontiac Fiero (1988)

A-1 Cardone Ind.® is a leading manufacturer and distributor of automotive parts and accessories, including master cylinders, clutches, calipers, and other braking system components. Its comprehensive range of products is made using the highest quality materials and the most advanced technology to ensure reliable performance, safety, and reliability. The company traces back its roots more than 35 years ago when Michael Cardone, Sr. remanufactures his first product: the windshield wiper motor. From then on, the name A-1 Cardone has been a go-to brand of automotive enthusiasts and fleet owners when it comes to new and remanufactured products that offer not just reliability but also long-lasting service.

Don't know your part number?

Take a photo and we'll identify it!

Recommended Products

More from A-1 CARDONE (Browse all)