A-1 Cardone 18-4342S - Brake Caliper
- Part Number
- 18-4342S
- Manufacturer
- A-1 CARDONE
- Description
-
Brake Caliper
details
$5449
+$42.00 Core Deposit
Total price w/ core: $96.49
MSRP: $92.60
Save: $38.11
In stock
limited availability at this price!
A-1 CARDONE part description
Product Description
Brake Caliper
Application Summary
AM General Hummer 2001-92; American Motors Concord 1983-82, Eagle 1988-82, Spirit 1983-82; Hummer H1 2006 2004-02; Jeep Cherokee 1992-84, CJ5 1983-82, CJ7 1986-82, Comanche 1992-86, Scrambler 1985-82, Wagoneer 1989-84, Wrangler 1989-87
Features & Benefits
- Pistons are durable, resistant to cracking or pitting and handle great loads.
- Rubber seals are replaced with new high temperature EPDM rubber for extended life and optimum performance.
- Mounting bracket is included where applicable for a hassle-free installation.
- Calipers are treated with a special formulated rust inhibitor and kept in the original equipment finish.
- New banjo bolts are included where applicable to ensure a perfect fit and quick installation.
- New bleeder screws provide trouble-free bleeding and a positive seal.
- New washers are included where applicable for a proper seal.
- A plastic cap plug protects every brake port thread to ensure trouble-free installation.
- New stainless steel hardware clips and new mounting pins are included where applicable.
- As a remanufactured Original Equipment part, this unit guarantees a perfect vehicle fit.
- Our remanufacturing process is earth-friendly, as it reduces the energy and raw material needed to make a new part by 80%.
Caliper, Brake Caliper, Disc Brake Caliper, Unloaded Caliper, Unloaded Brake Caliper, Power Brake Caliper, Hydraulic Disc Brake Caliper, Brakes
Product Attributes
Inlet Port Size | 0.38 |
Piston Quantity | 1 |
Piston Material | Steel |
Package Contents | Caliper; Instruction Sheet; Hardware Kit |
Bleeder Port Size | 3/8x24 |
Brake Caliper Finish | Oil Emulsion |
Installation Hardware Included | Yes |
Pads Included | No |
Mounting Bolts Included | No |
Product Condition | Remanufactured |
E-waste | No |
Piston Size (OD) (mm) | 65.94 |
Piston Size (OD) (in) | 2.60 |
FAQs | What type of grease is used on floating caliper mounting pins? |
Features and Benefits | Rubber seals are replaced with new high temperature EPDM rubber for extended life and optimum performance. |
Caliper Color | Gray |
Abutment Clips Included | No |
Anti-Rattle Spring Included | Yes |
Bleeder Screw Included | Yes |
9559 | 1 |
Bracket Included | No |
Caliper Casting Material | Cast Iron |
Caliper Color | Gray |
9611 | Oil Emulsion |
Caliper Slides Included | Yes |
Caliper Type | Floating |
Casting Number | 103707 |
Grade Type | Regular |
Inlet Fitting Type | Banjo |
9544 | 3/8x24 |
Mounting Bolt Included | No |
Mounting Bracket Included | No |
Mounting Hardware Included | Yes |
Mounting Hole Diameter | 17.41754 MM |
Mounting Hole Diameter | 0.686 IN |
9543 | 0.686 IN |
9543 | 17.41754 MM |
Pad Wear Sensor Included | No |
Pads Included | No |
7609 | 2.596 IN |
7609 | 65.9384 MM |
Piston Material | Steel |
Piston Quantity | 1 |
Bleeder Screw Cap Included | No |
Rust Resistant Coating | Yes |
Dust Boots Included | Yes |
Bleeder Thread Size | 3/8x24 |
Inlet Port Size | 0.375 IN |
Inlet Port Size | 9.52125 MM |
Contains Electronic Components | No |
Does it require SDS | No |
Is Item A Chemical | No |
Is Or Contains A Battery | No |
Is Or Contains A Bulb | No |
Is Prop Sixty Five Affected | No |
Is the item CARB affected | No |
FAQ_Q1 | Can I switch out a Phenolic Piston Caliper for a Steel Piston Caliper or vice versa? |
FAA_A1 | Not recommended. The O.E. manufacturers specified steel or phenolic pistons based on the intended use of the vehicle. It is recommended that the installer follow the manufacturer’s recommendations. |
FAQ_Q2 | What type of fluid should I use: DOT 3, DOT 4, or DOT 5? |
FAA_A2 | As a rule, always use brake fluid recommended by O.E. The fluid type is stamped on the master cylinder reservoir lid. Always use new fluid in a sealed container. |
FAQ_Q3 | Car pulls to one side during braking. Why? |
FAA_A3 | Inspect both calipers for binding or sticky slides or pins. Also ensure that brake hoses are not collapsed or restricted and inspect steering/suspension components for proper operation. |
FAQ_Q4 | Brakes squeal all of the time. What's causing the squeal? |
FAA_A4 | Brake squeal can be caused by improper installation of the brake pads, improperly installed brake hardware and improper brake rotor finish. |
FAQ_Q5 | Could calipers be the cause of a low brake pedal? |
FAA_A5 | A symptom of a low brake pedal is usually caused by air in the system, misadjusted rear brake shoes, deteriorated brake hose(s) or a defective master cylinder. |
FAQ_Q6 | What type of grease is used on floating caliper mounting pins? |
FAA_A6 | A silicone grease is used on floating caliper mounting pins. |
FAQ_Q7 | Do all of your Calipers come with the new hardware and a mounting bracket for installation? |
FAA_A7 | New hardware is included with all of our Calipers however the mounting bracket is an added option depending on part number and application. Mounting Brackets are also sold separately for most applications. |
Additional Information
Remanufactured Part | Y |
Warranty Distance | 24000 |
Warranty Distance UOM | DH |
Warranty Special UOM | TX |
Warranty Time | 24 |
Warranty Time UOM | MO |
Country of Origin (Primary) | US |
Harmonized Tariff Code (Schedule B) | 8708300050 |
Harmonized Tariff Code (HTS) | 8708305090 |
Canadian Harmonizing Tariff Code | 8708309920 |
UPC | 00082617489836 |
Part Interchanges
- AM General 06006898
- AM General 5572430
- AM General 6006898
- American Motors J8133846
- Jeep J8133847
- Hummer 05572426
- Hummer 05745452
- Hummer 5572430
- Hummer 5745452
- AM General 06006898
- Jeep J8133847
- Hummer 5745452
- American Motors J8133846
- AM General 6006898
- Hummer 05572426
- Hummer 05745452
- AM General 5572430
- Hummer 5572430
Fits Vehicles
- Hummer H1 (2002-2004, 2006)
- American Motors Spirit (1982-1983)
- American Motors Concord (1982-1983)
- American Motors Eagle (1982-1988)
- AM General Hummer (1992-2001)
- Jeep Wrangler (1987-1989)
- Jeep Wagoneer (1984-1989)
- Jeep Scrambler (1982-1985)
- Jeep Cherokee (1984-1992)
- Jeep Comanche (1986-1992)
- Jeep CJ7 (1982-1986)
- Jeep CJ5 (1982-1983)
A-1 Cardone Ind.® is a leading manufacturer and distributor of automotive parts and accessories, including master cylinders, clutches, calipers, and other braking system components. Its comprehensive range of products is made using the highest quality materials and the most advanced technology to ensure reliable performance, safety, and reliability. The company traces back its roots more than 35 years ago when Michael Cardone, Sr. remanufactures his first product: the windshield wiper motor. From then on, the name A-1 Cardone has been a go-to brand of automotive enthusiasts and fleet owners when it comes to new and remanufactured products that offer not just reliability but also long-lasting service.
California Proposition 65 Warning
Don't know your part number?
Take a photo and we'll identify it!