Cole Hersee 75907 - 75907 - 7590X Double Pole Switches Series

Cole Hersee Battery Selector Switches energize either or both of two batteries.
Master disconnect switches prevent tampering of theft when equipment is unattended.
Battery isolators prevent the battery with the higher charge from draining into the battery with the lower charge.
Battery-related accessories include remote battery jumper terminals, feed-through studs, lockout lever kits and face plates.
All products listed in this section can be found in Section J of the Cole Hersee D-275 CATALOG.

• Two positions: Off-On. For 6-36V DC systems.
• Will disconnect the batteryA collection of voltaic cells grouped together to provide higher voltage and/or higher current than a single cell. The battery is a common DC power source, especially for vehicles or equipment that is used remote from the domestic power supply.
•  
• Emergency vehicles and utility vehicles often have dual battery systems because of added power demand. Such systems necessitate the use of a Battery Selector Switch or a Low Voltage Disconnect Switch. and the alternatorCommonly refers to the DC charging device on an engine. The alternator is actually a three-phase AC device producing AC which is then rectified by a diode bridge to create direct current. In selecting a Battery Isolator, it's important to match the type of isolator to the alternator. or generatorA machine with rotating parts that is capable of generating electrical power. In the narrow definition 'generator' refers to a DC machine and 'alternator' refers to an AC machine. Sometimes the term generator is used to refer to AC machines as well. fieldTypically refers to a magnetic field. Specifically used when discussing the rotating electromagnetic field associated with an alternator. By varying the field current, thus its strength, the output of the alternator may be controlled. circuitA closed path (or loop) of electrically (or electromagnetically) connected components or devices that is capable of current flow. Typically consists of loads, sources, conductors, and circuit protection (circuit breakers and fuses). The path must be continuous and closed. .
• Electrical ratings: Large studs: 2000A intermittentSome switches are designed for infrequent (or intermittent) use. Devices such as solenoids may need a cooling period before they should be re-actuated. Rating a switch for intermittent use typically allows it to operate at a higher current than might otherwise be recommended. See continuous. You can use a Continuous Duty Solenoid in place of an Intermittent Duty Solenoid, but it would have a shorter life expectancy compared to the purpose-built Intermittent Duty Solenoid. DO NOT use an Intermittent Duty Solenoid in place of a Continuous Duty Solenoid!, 30 seconds On, 3 minutes Off. 300A continuous.
• Small studs: 20A continuous.
• Plated steel case. Chrome-plated diecast lever.
• Mounting stem 3/4" -16 thread, fits panels through 1/4" (6.4mm) thick.
• Two 1/2" -20 copper and two 10-32 studs.
• Sealed between shaft and mounting stem, and case and terminal insulator.
• With indexing pin. Also available as single poleThe number of separate circuits that can be active through a switch at any one time. So a switch can be rated SP or DP (Single or double pole). (75908).

COLE HERSEE 75907 Cross Reference

We have 1 alternatives for the 75907 by COLE HERSEE:

• CHS75907