A-1 Cardone 19B2916A - Brake Caliper
- Part Number
- 19B2916A
- Manufacturer
- A-1 CARDONE
- Description
-
Brake Caliper
details
We cannot fulfill orders for this part at this time. Please check back later or request a stock notification to receive an email.
Sometimes we may have similar parts for sale, click the button below to see if anything matches.
A-1 CARDONE part description
Product Description
Brake Caliper
Application Summary
Honda CR-V 2016-12
Features & Benefits
- Pistons are durable, resistant to cracking or pitting and handle great loads.
- Rubber seals are replaced with new high temperature EPDM rubber for extended life and optimum performance.
- Mounting bracket is included where applicable for a hassle-free installation.
- Calipers are treated with a special formulated rust inhibitor and kept in the original equipment finish.
- New banjo bolts are included where applicable to ensure a perfect fit and quick installation.
- New bleeder screws provide trouble-free bleeding and a positive seal.
- New washers are included where applicable for a proper seal.
- A plastic cap plug protects every brake port thread to ensure trouble-free installation.
- New stainless steel hardware clips and new mounting pins are included where applicable.
- As a remanufactured Original Equipment part, this unit guarantees a perfect vehicle fit.
- Our remanufacturing process is earth-friendly, as it reduces the energy and raw material needed to make a new part by 80%.
Caliper, Brake Caliper, Disc Brake Caliper, Unloaded Caliper, Unloaded Brake Caliper, Power Brake Caliper, Hydraulic Disc Brake Caliper, Brakes
Product Attributes
| Inlet Port Size | 0.39 |
| Piston Quantity | 1 |
| Piston Material | Steel |
| Package Contents | Caliper; Instruction Sheet; Bracket; Hardware Kit |
| Bleeder Port Size | M10x1.0 |
| Brake Caliper Finish | Oil Emulsion |
| Installation Hardware Included | Yes |
| Pads Included | No |
| Mounting Bolts Included | No |
| Product Condition | Remanufactured |
| E-waste | No |
| Piston Size (OD) (mm) | 56.97 |
| Piston Size (OD) (in) | 2.243 |
| FAQs | What type of grease is used on floating caliper mounting pins? |
| Features and Benefits | Rubber seals are replaced with new high temperature EPDM rubber for extended life and optimum performance. |
| Caliper Color | Gray |
| Abutment Clips Included | Yes |
| Anti-Rattle Spring Included | Yes |
| Bleeder Screw Included | Yes |
| 9559 | 1 |
| Bracket Included | Yes |
| Caliper Casting Material | Cast Iron |
| Caliper Color | Gray |
| 9611 | Oil Emulsion |
| Caliper Slides Included | Yes |
| Caliper Type | Floating |
| Casting Number | 5735 |
| Grade Type | Regular |
| Inlet Fitting Type | Banjo |
| 9544 | M10x1.0 |
| Mounting Bolt Included | No |
| Mounting Bracket Included | Yes |
| Mounting Hardware Included | Yes |
| Mounting Hole Diameter | 0.472 IN |
| Mounting Hole Diameter | 11.98408 MM |
| 9543 | 11.98408 MM |
| 9543 | 0.472 IN |
| Pad Wear Sensor Included | No |
| Pads Included | No |
| 7609 | 56.97 MM |
| 7609 | 2.243 IN |
| Piston Material | Steel |
| Piston Quantity | 1 |
| Bleeder Screw Cap Included | No |
| Rust Resistant Coating | Yes |
| Dust Boots Included | Yes |
| Mounting Hole Thread Size | M14x1.5 |
| Bleeder Thread Size | M10x1.0 |
| Inlet Port Size | 10.00366 MM |
| Inlet Port Size | 0.394 IN |
| Contains Electronic Components | No |
| Does it require SDS | No |
| Is Item A Chemical | No |
| Is Or Contains A Battery | No |
| Is Or Contains A Bulb | No |
| Is Prop Sixty Five Affected | No |
| Is the item CARB affected | No |
| FAQ_Q1 | Can I switch out a Phenolic Piston Caliper for a Steel Piston Caliper or vice versa? |
| FAA_A1 | Not recommended. The O.E. manufacturers specified steel or phenolic pistons based on the intended use of the vehicle. It is recommended that the installer follow the manufacturer’s recommendations. |
| FAQ_Q2 | What type of fluid should I use: DOT 3, DOT 4, or DOT 5? |
| FAA_A2 | As a rule, always use brake fluid recommended by O.E. The fluid type is stamped on the master cylinder reservoir lid. Always use new fluid in a sealed container. |
| FAQ_Q3 | Car pulls to one side during braking. Why? |
| FAA_A3 | Inspect both calipers for binding or sticky slides or pins. Also ensure that brake hoses are not collapsed or restricted and inspect steering/suspension components for proper operation. |
| FAQ_Q4 | Brakes squeal all of the time. What's causing the squeal? |
| FAA_A4 | Brake squeal can be caused by improper installation of the brake pads, improperly installed brake hardware and improper brake rotor finish. |
| FAQ_Q5 | Could calipers be the cause of a low brake pedal? |
| FAA_A5 | A symptom of a low brake pedal is usually caused by air in the system, misadjusted rear brake shoes, deteriorated brake hose(s) or a defective master cylinder. |
| FAQ_Q6 | What type of grease is used on floating caliper mounting pins? |
| FAA_A6 | A silicone grease is used on floating caliper mounting pins. |
| FAQ_Q7 | Do all of your Calipers come with the new hardware and a mounting bracket for installation? |
| FAA_A7 | New hardware is included with all of our Calipers however the mounting bracket is an added option depending on part number and application. Mounting Brackets are also sold separately for most applications. |
Additional Information
| Remanufactured Part | Y |
| Warranty Distance | 24000 |
| Warranty Distance UOM | DH |
| Warranty Special UOM | TX |
| Warranty Time | 24 |
| Warranty Time UOM | MO |
| Country of Origin (Primary) | US |
| Harmonized Tariff Code (Schedule B) | 8708300050 |
| Harmonized Tariff Code (HTS) | 8708305090 |
| Canadian Harmonizing Tariff Code | 8708309920 |
| UPC | 00884548115217 |
Part Interchanges
Fits Vehicles
- Honda CR-V (2012-2016)
A-1 Cardone Ind.® is a leading manufacturer and distributor of automotive parts and accessories, including master cylinders, clutches, calipers, and other braking system components. Its comprehensive range of products is made using the highest quality materials and the most advanced technology to ensure reliable performance, safety, and reliability. The company traces back its roots more than 35 years ago when Michael Cardone, Sr. remanufactures his first product: the windshield wiper motor. From then on, the name A-1 Cardone has been a go-to brand of automotive enthusiasts and fleet owners when it comes to new and remanufactured products that offer not just reliability but also long-lasting service.
California Proposition 65 Warning
California Proposition 65 Warning
WARNING: This product can expose you to chemical which is known to the State of California to cause cancer and birth defects or other reproductive harm. For more information, go to www.P65Warnings.ca.gov. (Read more)
Don't know your part number?
Take a photo and we'll identify it!
